Uji Tekan Batako Ringan dari Limbah Pengolahan Emas dengan Variasi Komposisi Abu Sekam Padi

Syahrun Syahrun, Sukainil Ahzan, Dwi Pangga

Abstract


[Title: Test Press Concrete of Gold Processing Waste With Variation of Rice Husk Ash Composition]. Lightweight concrete has been made from waste raw materials processing of gold and ash husk of rice with cement as the supporting materials, foam, and ADT. The purposed light brick-making determined the density and compressive strength. Concrete light created by variations in waste processing of gold and ash husk of rice was respectively 10% LPE + 90% ASP, 25% + 75%, 50% + 50%, 75% + 25%, 100% + 0% (in% volume), hardening time for 11 days. Parameter test performed include density test and compressive strength test. Test results showed that the density and the compressive strength of lightweight concrete with a variation of plus gold processing waste and ash husk of rice, the amount of cement on the conditions remained and the drying time for 11 consecutive days, the density of 1.005 gr/cm3, 0.986 gr/cm3, 1.077 gr/cm3, 1.091 gr/cm3, 1.133 gr/cm3 and the compressive strength of 1.34 MPa, 1.16 MPa, 1.77 MPa, 1.03 MPa, 1.29 , The intensity of the density and the compressive strength was influenced by the amount of foam mix, rice husk ash and ADT.

Keywords


waste processing of gold; ash husk of rice; lightweight concrete

Full Text:

PDF

References


Anik, R. (2014). Pengaruh Penambahan Sekam Padi pada Campuran Beton Ringan Non Struktural Terhadap Nilai Penyerapan dan Nilai Kuat Tekan Beton Campuran Semen, Kulit Kopi, dan flyash. Simposium Nasional RAPI XIII- 2014. ISSN 1412-9612. Universitas Jember.

Anis, R. (2014). Lockbrick Modular Beton untuk Alternatif Bahan Dinding yang Memenuhi Mutu SNI dengan Biaya Murah. Sinektika, 14(2),-.

Budirahardjo, S. (2014). Pemanfaatan Sekam Padi pada Batako. Prosiding SNST ke-5 Tahun 2014. Semarang, Indonesia: Universitas Wahid Hasyim.

Hendra, R. (2009). Pemanfaatan Limbah Tambang Untuk Bahan Konstruksi Bangunan. EKOTON 9(1),69-73.

Hendrawati, A. (2013). Identifikasi intrusi limbah pertambangan emas liar dengan menggunakan metode geolistik 3D. Tesis. Universitas Negeri Semarang.

Iin, S., Prasetya, D., S., B., & Ahzan, S. (2018). Penggunaan Eceng Gondok Sebagai Filler Untuk Meningkatkan Kuat Mekanik Batako Ringan Berbahan Dasar Limbah Emas. Jurnal Kependidikan Lensa 6(2), 53-58.

Iman, S. (2008). Batako Styrofoam Komposit Mortar Semen. Forum Teknik Sipil No. XIII/2-Mei 2008. UGM Yogyakarta.

Kristianingrum, S. (2009). Kajian Teknik Analisis Merkuri yang Sederhana, Selektif, Prekosentrasi, dan Penentuannya Secara Spektrofotometri. Prosiding Seminar Nasional 16 Mei 2009. Yogyakarta, Indonesia: Universitas Negeri Yogyakarta.

Pitoi, M.M. (2014). Sianida. Klasifikasi, Toksisitas, Degrasi, Analisis (Studi Pustaka). Unstra. Manado.

Sumbawaty, N., Ahzan, S., & Prasetya, D., S., B. (2018). Uji Porositas dan Kuat Tekan Batako Ringan Berbahan Dasar Limbah Pengolahan Emas (LPE) dengan Filler Pohon Pisang (FPP). Jurnal Penelitian dan Pengkajian Ilmu Pendidikan: e-Saintika, 1(2), 87-93.




DOI: https://doi.org/10.36312/e-saintika.v2i2.112

Article Metrics

Abstract view : 45 times
PDF - 73 times

Refbacks

  • There are currently no refbacks.


Copyright (c) 2019 Syahrun Syahrun, Sukainil Ahzan, Dwi Pangga

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Creative Commons License
Jurnal Penelitian dan Pengkajian Ilmu Pendidikan: e-Saintika is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
View e-Saintika Stats

e-Saintika Abstracting & Indexing
This journal has been covered by the following indexing and abstracting services:

ORCID iD iconhttps://orcid.org/0000-0003-1258-5969

[Valid Atom 1.0]